There is a small bubble in my traction pad, is this normal?

Yes. During the installation of the pad air can get trapped between the board and the traction. The air can expand under heat causing a small bubble under the traction. You can ‘pop’ the bubble with a needle to release the air and re-adhere the traction pad to the board....Read More

How does the vent plug work?

The vent is installed to allow air to escape from the EPS foam core. As the air in the foam expands due to a rise in temperature it must be allowed to escape from the board or risk delaminating, Delamination is caused when this air forces separation from the EPS core and epoxy shell, causing […]...Read More

Does my air vent need maintenance?

The air vent is automatic and does not need to be open or closed for use. It is recommended that you remove the vent cap by unscrewing it periodically to keep it clear from any debri that may block it from working properly....Read More

How do I store my board?

It is recommended you store you board in a well ventilated room, out of direct sunlight. The temperature within the room should not fluctuate outside of 50-85 degrees....Read More